• Look Solutions Viper NT DMX Fog Machine

Look Solutions Viper NT DMX Fog Machine

$1,250.00 $1,095.00
(You save $155.00)


Special order. Usually ships in 1-3 business days.
Free Shipping

The Viper nt originate from the continued development and improvement of the Viper fog machine.

It unites the current digital technology with the proven technik and power of its predecessor.

New features guarantee a much more simple operation – place and fog, reducing the amount of time needed to set up the machine.


  • Control panel
    The control panel with LED-display, simple symbols allow for easy operation. It also protects the control buttons against dirt.
  • Finest adjustments of the output
    Digital technology makes fine adjustment of the pump possible. In steps of 1% the output can be adjusted from 0 - 99%. Thus, any desired effect from a tiny fog-cloud to the thickest fog can be produced. This enables the Viper NT to be used in both small and large locations.
  • DMX 512 as standard
    The Viper NT can be controlled via DMX 512. The connection is done with 5pin-XLR-plugs.

    The DMX start address can be adjusted and saved via the control panel.
    If an external fan is connected to the machine it can be controlled separately via DMX as well and can be used as a wind machine.

    The machine can also be controlled with analog (0 - 10 V) via a lighting desk or via XLR-remote (option). This connection is done with 3pin-XLRplugs.

    A stand-alone-mode is also possible. The adjustments are done directly at the machine. A short press at the start button makes the machine run. Therefore a permanent pressing of the start button is unnecessary.
  • Internal timer
    With the internal timer the fog time can be exactly adjusted in seconds, the wait time in minutes and the output in %.


The change of the design is not only cosmetic, it also has improved safety features.

The Viper NT is equipped with new safety features.

On the front and the back part of the cover there are fixing points for safety bonds.

At both sides of the bottom of the machine are three holes to which a hanging yoke complete with a collecting tray for fluid drips can be fixed.


The following Look-fog fluids are available for the Viper NT:

  • Quick-Fog (thick, quick disappearing fluid)
  • Regular-Fog (thick, long lasting fluid)
  • Slow-Fog (thick, extremly long lasting fluid)

Technical Specifications:

Procedure vaporizing fog machine
Power requirement 1300 Watt
Voltage 230V / 50 Hz or 120V / 60 Hz
Warm up time approx. 7 min.
Fluid consumption
at max. output
at continuous output

120 ml/min.
35 ml/min
Fluid tank

5 liter
Fog output adjustable in 99 steps
Output projection approx. 15 m
Fogging time
at < 50% output

continuous output
Control DMX 512
0 – 10 V analog
Stand alone mode
Radio remote (option)
Temperature control Microprocessor controlled
Overheating protection Heater block/Thermostat
Pump/Thermal switch
Dimensions (L x W x H)
without tank housing
18.5" x 9" x 9.5"
47 x 23 x 24 cm
Weight 19 lbs. / 8.6 kg


Made in Germany.